• Transmitter for angular position KINAX 2W2 (according to Order)
• 3 clamps 
• Operating instructions in German, French, English and Russian 
• Type examination certificate, only with ATEX-approval

The output is a load-independent DC current signal of 4…20 mA proportional to the measured value.

• Patented contact free capacitive sensor system
• Measuring range, direction of rotation, characteristic, switching point and other additional functions programmed using PC / Simplifies project planning and engineering, short delivery times, low stocks
• Measuring range of angle of rotation: 0…10 to 0…50 or 0…50 to 0…350°
• Measuring output (output/powering circuit) in two-wire connection (4…20 mA signal)
• Very low torque (< 0.001 Ncm, with 2 mm shaft)
• Advantage: The shaft can be rotated practically without any reaction effects and is therefore not a «load» on the connected devices.
• Compact size, only 48 mm diameter
• Advantage: it can be installed anywhere (OEM)
• Type of protection “Intrinsically safe” Ex ia IIC T6 / Can be mounted within the hazardous area
• Simulation of measured values / The testing of the subsequent device chain is already possible during the installation phase
• Measured value acquisition / Display of the instantaneous value and a trend graph of the measured value on the screen
• Adjustment / Independent fine adjustment of the analog output, zero position and measuring range
• Characteristic of the output value / Programmable as a linear, V-characteristic, or any characteristic curve
• The shaft can be turned through a full 360°
• Serial interface